Interlocked 3
Interlocked 3
3D
Published 2018-01-10T18:51:18+00:00
Three interlocked twisted rings, mathematically generated (thanks to MathMod).
Depending on wrist size, it might even make a bangle - just adjust size to suit. Reduced to a small enough size, it might make a ring (although might be a bit bulky between fingers). Perhaps use as a pendant by just adding it to a neckchain.
Regardless, figuring out how it was made is a sure conversation piece. There are no joins, so how is it created?
Designed for Sinterit Lisa.
Printing this on a filament printer would be a nightmare, if not impossible. Who wants to clean up all the support necessary for this to filament print? Not me, for sure.
Cura does produce GCODE so the design is manifold. Unfortunately, I do not have a Sinterit LIsa to try it, but it looks good to go.
If you want to bling it up, I suggest a couple of coats of glossy gold or chrome. Or, if you are keen, handpaint each twisted ring a different colour.
| 发表的日期 | 10/01/2018 |
| 尺寸大小 | 90 x 90 x 30.9 |
| 打印工艺 | SLS |
| 复杂程度 | 容易 |
