Lars Ulribs
$15.00 Lars Ulribs
3D
Published 2023-09-05T09:27:09+00:00
Why pay for this single file when you have over one thousand more for a lot less? That’s right. STLFLIX is a multi-theme ever-growing library of STL files. Your One-Stop-Shop for Premium 3D-Printing models. Get started with the Ultimate STL platform!
Lars Ulribs
This STL file is recommended for FDM Printers!
3D Printing Time: 2 Days 07 Hours and 55 Minutes
Approximately Height: 26cm
I don’t know about you, but for me, this guy looks a bit drummatic.
Assembling Instructions:
Take GEAR_1 and tighten the spring with your fingers as shown in the video, and place it inside BODY, fitting the outer hole of the spring onto the pin inside BODY.
Fit GEAR_3 onto GEAR_2 and attach it on top of GEAR_1 so that GEAR_3 is facing downwards.
From the outside, thread GEAR_8 so that the pin goes through the holes of the aligned gears on the inside.
Attach GEAR_4 onto the pin of BODY.
Attach GEAR_5 onto the top of GEAR_3, through the pin of GEAR_8.
Place GEAR_6 on top of GEAR_4.
Fit CHEST_PLATE on top of everything, aligning the pins with the holes and the slots on the side, as shown in the video.
Put GEAR_7 over CHEST_PLATE, fitting it onto the first pin.
Attach CHEST_ELIPSE so that the inner diameter touches GEAR_7, as shown in the video.
Fit CHEST_ELIPSE_SLIDER below CHEST_ELIPSE, in its designated space.
Finish by attaching and gluing the remaining parts, following the assembly from the video.
COPYRIGHT & SELLING RIGHTS
This STL file is copyrighted by STLFLIX©, the Ultimate STL Subscription. This means you can print it for yourself, but you DO NOT have the right to sell it.
To acquire copyright & selling rights, you must subscribe to our Commercial License. By doing so, you will also get immediate access to over 500 STL files, unlimited downloads, and marketing content for every single file.
Go commercial and skyrocket your own store with STLFLIX!
USEFUL LINKS
Get to know us a little better!
Website | Instagram | TikTok |Twitter
What are you waiting for? Join thousands of other makers from all around the world.
HAPPY PRINTING!
Line Width/ Nozzle: 0.4 mm
Average Speed: 20mm/s (First Layer) / 50mm/s (All the other layers)
Recommended Initial Layer Height: 0.12 mm
Recommended Layer Height: 0.12 mm
Recommended Perimeters/ Walls: 3.
Recommended Infill (%): 10% (Gyroid)
Needs Support: No.
Build Plate Adhesion: None.
The parameters above are recommendations made by our staff; if you prefer, you can adapt them according to your preferences.
| 发表的日期 | 05/09/2023 |
| Price | $15.00 |