Mobula 6 Case
Mobula 6 Case
3D
Published 2020-02-04T17:03:08+00:00
The HappyModel Mobula 6 is a great little whoop sized quadcopter. However, it does not come with a case and I made this to fit my needs. Hopefully it works for you. This is not perfect by any means but it is a start. It can hold 6ish batteries, many props, a few tools, and the lid slides on and does not easily fall off. The first few closes of the lid can be tighter.
Printing
Body: I printed it at 0.2 layer heights and .4 width. The inner walls are 1.6mm so clean/fast printing may benefit from a factor of that. There are no real hiccups to watch out for if you are moderately dialed in.
Lid: Print plain if you would like. You might get away with a few % over scale if you think the lid has too much slop. Currently there is 0.25mm on each mating surface. The taper should print decently as it is 45*.
I made a version with inset letters for fun. Import both the lid with relief and the letters into the slicer at the same time. They should import alligned but please ensure that the letters line up exactly with the relief. Turn the visibility off on one part and slice. Repeat for the next part. Print the letters first to ensure you get a clean first layer. Remove the keying ring I've added, change filaments, and print the rest of the lid.
| 发表的日期 | 04/02/2020 |
| 支持自定义 | YES |