Mycologist Mask of Inscryption
Mycologist Mask of Inscryption
3D
Published 2023-01-23T13:36:52+00:00
The other iconic mask of Inscryption ready to be printed in anything but they would prefer mushrooms.
The Mycologist are especially weird character in Inscryption but they also just like to combine two into one.
Print it as the whole thing. (The full version is only recommended for SLA printers because of all the thin parts and overhangs!)
Or split using the files in the zip. You find a basic sub structure where each sub folder means another split. All can be put together using the connector bit without glue.
The default size is for ca 24 cm average man head height with a lot of playroom. (They work either way)
You can of couse also print it small and hang it on the wall.
In case you want to make it wearable with just the glasses hangers holding into onto your head you might need to print it more like 90%.
More details in the readme.
Support required.
There are also optional eye pieces. Either plain eyes or swirl eyes. Both can also be combined with glue to create a orange swirl with black back. Or glue on the pupils.
Note: The 3d files are for private Non-Commercial use only! But feel free to print it through any print serves like Treatstock.
More Inscryption:
You find more Inscryption prints under my account.
Want to check out more masks of Inscryption? Go here: artstation.com/artwork/8edk1n
Never heard of the game? This is a good start: inscryption.com
Readme:
The full version is only recommended for SLA printers because of all the thin parts and overhangs!
For the split version it is recommended to print the 2 heads separate since the combined version still has different bottom angles.
Almost everything requires support!
There is also a more split version you can use for smaller printers.
You can use the ConnectorSub.stl bit to connect all the pieces without having to use glow.
However the Head Mirror requires glue. The glass pieces of the glasses should snap into place but you might still want to use glue.
There are optional eye pieces you put into the mask eyes slots from the back. For the Mushroom HeadB you need to print them at 55% then.
If you want to wear it as the Mushroom HeadB scale the print accordingly.
You could also only print the the mushroom HeadB part and attach it to your real head.
However you might want to find a better solution than glue since it will most certainly come off after taking showers.
Glasses:
For Head B print the glasses at 60% size!
For the glasses glass you could also use clear plastic instead and cut that to the shape.
Mushroom HeadB needs the Glasses to be print at 60%!
The Shell versions of the actual glasses are meant to print thin with transparent material. (Raft and support needed)
60% For the small glasses!
You can print the Solid versions instead if that is too hard to print for you.
You might want to glue the glasses onto the actual mask to be able to properly wear it without strings.
| 发表的日期 | 23/01/2023 |