pick locket
2,516
views
159
downloads
1
collection
0 comments
Loading comments... 
pick locket
3D
Published 2017-08-14T14:47:13+00:00
27
0
Add to Collection
Description
Here is a small container to keep picks in. The lid swivels open on a pin and then snaps back into place.
There are two versions of the pin--one has a slightly larger diameter than the other one--because I've found that not all my filaments print out to exactly the same size. The pin should fit snugly enough that pliers or a hammer tap is needed to seat it completely.
A raft is strongly advised for printing the pin. Otherwise no supporting material is necessary.
There is also a small hole in the top for stringing it on a cord if desired.
Technical Information
| 发表的日期 | 14/08/2017 |
| 打印工艺 | FDM |
| 复杂程度 | 非常容易 |
More Information
Object Parts