Print Head Fan Holder for Geeetech A10
Print Head Fan Holder for Geeetech A10
3D
Published 2020-01-05T17:15:13+00:00
This is a Print Head Fan Holder for Geeetech A10 printer.
The front fan is replaced and a side extractor is added.
Print Settings
1 x PrintHeadFanHolder : Layer:0.15mm Raft:no Support:yes Infill:100%
1 x PrintHeadFanDuct : Layer:0.15mm Raft:no Support:no Infill:100%
Accessories
2 x m2x15mm SHCS (Use existing) for the fan duct
2 x m3x16mm SHCS for the side extrator
2 x m4x20mm SHCS for the front fan
Front fan : https://www.amazon.fr/gp/product/B07K6GKH26/ref=ppx_yo_dt_b_asin_title_o01_s00?ie=UTF8&psc=1
Side extractor : https://www.amazon.fr/gp/product/B07CV6VTWB/ref=ppx_yo_dt_b_asin_title_o02_s00?ie=UTF8&psc=1
Dupont cables : https://www.amazon.fr/gp/product/B01JD5WCG2/ref=ppx_yo_dt_b_asin_title_o05_s00?ie=UTF8&psc=1
Mounting
/!\ The fan cables are connected by dupont connectors to allow assembly and disassembly.
If necessary, you must cut some part on the right side of the hotend cage to pass wires.
Mount the PrintHeadFanHolder on the hotend cage.
Connect the wires of the front fan with the connectors dupont by passing them through the frot hole provided for this purpose. Be careful of the polarity.
Fix the front fan with the two m4 screws.
The side extractor is connected on the 24V port avalaible on the back of the hotend (loot at picture).
Connect the wires of the side extractor on the PrintHeadFanHolder with the two m3 screws.
Mount the PrintHeadFanDuct on the PrintHeadFanHolder with the two original m2 screws.
Note : the side extractor is constantly on.
| 发表的日期 | 05/01/2020 |