Printable Hand Vise
2,013
views
91
downloads
1
collection
0 comments
Loading comments... 
Printable Hand Vise
3D
Published 2020-04-26T15:30:20+00:00
22
0
Add to Collection
Description
When working with small models sometimes my fingers just are too big. So I made a fully printable hand vise.
Print everything in PLA with a layer height of 0.2mm or lower. Support is not needed. The thread is close to M12 and should work directly after printing. Lubricating the thread is recommended - I am using candle wax for that. If you want, you can re-cut the thread with an M12 tapper, but that should not be necessary.
For the hinges I designed hinge rivets. To install the claws insert the claws and the hinge rivets, heat up a screwdriver and press it on the small end of the rivet. The rivet will melt in place.
允许
Technical Information
| 发表的日期 | 26/04/2020 |
| 支持自定义 | YES |
More Information
Object Parts