Pyran by Jimmy Eitan
- 同人作品>
- 手办 |
- Tabletop>
- NSFW |
- Anime & Manga
Pyran by Jimmy Eitan
3D
Published 2022-02-28T11:40:35+00:00
I got a request to print this figure. But man, did it have errors. The hair was disconnected so that it looked like a wedge was taken out of her head with an axe. The body was so poly that it lost all detail, and the pony tail was so thin that it just popped off.
For FDM printing, I set the costum supports and blockers. You can rearrange it how you'd like. Previously, I tried printing with the supports coming from the back, as if she was rotated 90degrees backward. I didn't like removing the supports in between the arms. I did a lot of sanding from that to get the markings off her butt, too. I think this positioning is better. It'll be easier to clean up the base and then spray paint it down.
You're gonna want to set horizontal expanse to .2-.3mm so those fingers get some depth.
I've got no idea who Pyran is, but the original by Jimmy Eitan can be found on Thingiverse:
https://www.thingiverse.com/thing:3179194
| 发表的日期 | 28/02/2022 |