Replacement Pimoroni Fan Shim Duct
Replacement Pimoroni Fan Shim Duct
3D
Published 2020-09-08T18:40:15+00:00
Had a Pimoroni Fan Shim shipped to me with the fan broken away from it's duct. Whilst waiting for a replacement, I decided to move ahead with a project, and decided designing a replacement fan duct was in order.
The fan's central motor hub was intact, so I simply created a duct with mounting point for the hub to press into, along with stronger tabs holding it in place.
Fan works as intended with no spin slowdown. The fan's height is only ~.5mm higher than the original.
Standard Print Settings:
Extruder: 210C
Bed: 56C
First Layer Print Height: .24mm
Wall Thickness: .40
Wall Perimeters: 2
Supports are only needed for side mounting tabs)
Supports Percentage: 15%
Support Pattern: ZigZag
| 发表的日期 | 08/09/2020 |