speedybee 5' freestyle drone frame skins
speedybee 5' freestyle drone frame skins
3D
Published 2022-10-24T16:25:33+00:00
These are the parts I fly on my daily basher. My fav frame to fly by far, the speedybee 5in freestyle squashed x. Visit my YouTube channel to see it in action. It is Durable AF.These skids are the same ones I use on the Tbs SourceOne bc they are tough and have soft landing. The rear antenna mount is for an immortal T and an analoge antenna mount. I fly backwards a lot and tend to destroy and krinkle up my antennas. This rear is designed to take the impact and roll over the antenna. I have broken lots of vtx because of impacts to the antenna and mcx movement.
The gps is off to the side which in my wxperience has been the most protected place for the gps antenna. It slides in from the side and locks in place. The antenna clicks firmly in place under tabs at the coners. This location puts the gps as far away from the motors andother antennas as possible. i dont use shielding on the wires or any of that and I get quick sat lock.
The vbat wire guard has special instructions. It prints well with no support but you will notice there are two vertical slits on one of the tubes. Use a razor to cut horozontally connecting the two vertical slits as shown in the pictures. Next install the lower portion and rout your wires inside the tube. Next install the top portion onto the standoff which will securely trap your power wires and shield them from prop strike. A little bit of form and a little bit of fasion but tough as nails. Very few things have needed revision over the last two years and now Im presenting it to you.
Most files are tpu parts with no support. Nozzel temp 190-200. Bed temp 65-70. Fan 80%. Use a .05mm nozzel to print faster better looking parts. I use 5-8% infill
If the stl appears tiny then scale it up unifomly by multiplying one of the dimensions by 25.4 this converts inches to mm. Files are in inches. If your slicer is in mm the stl will be tiny.
| 发表的日期 | 24/10/2022 |
| 让时间去下载 | 120 - 分钟 |
| 材料数量 | 15 |
| 支持自定义 | YES |