Spool Holder + End Cap
Spool Holder + End Cap
Published 2023-09-04T10:11:41+00:00
3D PRINTING FILAMENT SPOOL HOLDER WITH END CAP.
I recently ran into a tangling problem for the first time, so after spending hours respooling a new roll of filament, i knew i had to upgrade my setup, because this will definately happen again and again.
I wanted something simple and efficent, but at the same time, i didnt want to waste a bunce of plastic if i didnt have to.
This lightweight spool rod is perfect for 1KG spools, and can be secured using the end-cap.
The print will take around 5 hours with the following parameters:
Material: PETG
Speed: 60mm/s
Layer Height: 0.2mm
Wall Count: 3
Nozzle Size: 0.4mm
NO SUPPORTS ARE NEEDED.
Total Print Time - 5 hrs 27 min
Total Filament Use - +- 51g or 17.3m
Feel free to remix this design.
发表的日期 | 04/09/2023 |
让时间去下载 | 5 - 27 分钟 |
材料数量 | 51 |
尺寸大小 | 90x90x75 |
支持自定义 | YES |