I designed this tooth brush holder to keep debris off my tooth brushes and to prevent my cat from playing with them. Nothing is worse than knowing if your brushing your teeth with a mixture of toothpaste and cat residue. Will also accept 2-3 standard razors as well.
There are holes on the base of the body which allow airflow and water to freely drip off the tooth brushes and not sit in the holder for a clean area. I would highly recommend spraying this with a spray paint or other sealant to seal it as I have heard PLA allows bacteria to grow easily.
No supports are needed for this print. There are two small supports on the hinge pins for the lid that with either pop off or require snipping.
Print at .15 or better layer height.
There are two indents for accepting 3M command poster size strips or 2 holes for #8-10 screws. Of course you could also use suction cups if the holes work or regular double sided tape. The recess helps the tape hug the wall better.
PowerSpec/Wanhao i3 Plus
.15 or better