Weathered Wyzetrap Cover
Weathered Wyzetrap Cover
3D
Published 2019-11-08T19:37:10+00:00
I created this cover/decoration for the Wyze Competition.
I decided to create this cover to resimble the design of claptrap from Borderlands with a weathered look.
Designed with main camera cover as one piece with little or no need for supports. Includes a opening for usb plug on the rear side and ventalation to reduce possibility of over heating.
Depending on your printer, support may be needed for openings. I would use tree supports and would print the whole design on a 45 degree angle.
A nice paint job should help this stand out!
I would print this using PLA at .16 or .2 layer height.
Infill 20% to 100% I printed the ecample at 5% infill and a couple of the vents on the back side started to separate. The other one I printed at 20% was pretty solid!
Depending on your printer, support may be needed for openings. I used tree supports and printed the whole design on a 45 degree angle.
Printed with a brim.
| 发表的日期 | 08/11/2019 |
| 让时间去下载 | 444 - 445 分钟 |
| 材料数量 | 73 |
| 尺寸大小 | 76.3mm x 68.4mm x 57.5mm |
