Yet Another Catan Tile Holder
Yet Another Catan Tile Holder
3D
Published 2019-02-05T17:17:53+00:00
This is a small footprint rack for the magnetic catan tiles from Dakanzia plus the hexagonal spacer rings from his storage solution.
I found that the storage was both too bulky to print on my Robox, and too costly (it's almost 500g) which makes it someone impractical (although beautiful). This should print out at about 33grams including supports. The flanges on either side make it so that you can snug them next to each other in rows without the tiles pressing laterally. Someone who is more clever than me can likely come up with a magnetic seating mechanism. These are meant to sit in a box or briefcase and hold the pieces on edge with the help of the spacer rings. Fully loaded the racks are about 83mm tall.
Printer Brand:
CEL
Printer:
Robox
Rafts:
No
Supports:
Yes
Resolution:
Draft (Low)
Infill:
20%-30%
| 发表的日期 | 05/02/2019 |
