swill01's Print of Make Anything Mystery Puzzle Box
Community Print 3D Print of Make Anything Mystery Puzzle Box
Published 2019-10-23T14:53:53+00:00
0
2
Printed on: Creality Ender 3
Material: PLA
Description
Two attempts and both failed at approximately the same point. I didn't see the issue on the first print, but did see it on the second. On the second print, the print head started hitting the model. I did find that my carriage wheels were a little lose, but not ready to try another 2 day print at this time.
The first print is on the right. I found out from watching the second happen that the offset was caused by the head hitting the print and physically moving the build plate (attached with 4 binder clips) to the side of the heated plate, thus causing the offset. I stopped the second one myself....
I had the infill at 20%.... could it be less to speed up the print?
Any other suggestions?