chrysshart's Print of 3 Wise Bendys
Community Print 3D Print of 3 Wise Bendys
Published 2023-04-20T22:09:39+00:00
0
0
Printed on: ELEGOO Mars 2 Pro
Material: Resin
Description
I printed three sets of these for my kid's 8th-grade class and they turned out perfectly! I have an Elegoo Mars 2 Pro and did these in SUNLU ABS-Like Light Grey. I used Lychee Slicer Pro to hollow, support, and slice them and acrylic to paint them. I did run out of resin on one set (my fault) so it was a tiny bit short, but it was close enough I could fill in the gap with some resin and old rafts and then reshape and paint over. Btw, I was able to get all three with their bases onto my build plate in one run.