Decidingfactor's Print of Fudge Dice
Community Print 3D Print of Fudge Dice
Published 2023-08-26T00:40:36+00:00
0
0
Printed on: ELEGOO Mars 2 Pro
Material: Resin
Description
Printed on a Elegoo Mars 2 Pro using standard Elegoo Resin, 0.05 mm layer height and 3 second exposure. All models set at x=16mm for standard d6 sizing. I printed them at x axis +45 degrees and 3 mm height above the print plate. This allowed for adequate supports under the lower edge, and the 45 degree angle meant I didn't need to have any internal supports going inside the hollow dice to support the top of the print. The Botanical and Thorn models are pretty light at this size/material, but you would just have to roll them gently so they don't fly away. Overall excellent models, and I'm super pleased with the results :)