GBM7925's Print of Angry Librarian | 213mm
Community Print 3D Print of Angry Librarian | 213mm
Published 2024-01-28T11:52:22+00:00
2
2
Printed on: Anycubic Photon Mono M5s
Material: Resin
Description
I could not get the sword to sit on the ground as shown in the originators photos. I tried various combinations of hand to lower arm and lower arm to upper arm, they are both on square pegs & holes so there are limited combinations and although I could nearly get the end of the sword onto the ground the arm did not look right so I just chose what felt like the best fit and she will just have to hold it up off the ground. Other than that the assembly went together very well.