randerson1983's Print of Ports/Harbours for the Boardgame "Merchants & Marauders" or in german "Korsaren der Karibik"
Community Print Impresión 3D de Ports/Harbours for the Boardgame "Merchants & Marauders" or in german "Korsaren der Karibik"
Published 2019-08-05T13:06:27+00:00
0
4
Impreso con: Creality Ender 3 Pro
Material: PLA
Descripción
Here are (plenty of!) images of my print.
I hadn't realised that the towers should have four sides until after printing all the English ports - but the two thin walls on the models didn't print. My solution was to put a few turns of cling film around the base of each flag pole so it's nice and snug.
Without the thin walls, there were four model i had to edit to get an intact tower (Trinidad, San Juan, Havana and Curacao).
I used 0.16mm layer height and 20% in-fill