Book Hide (small)
Book Hide (small)
3D
Published 2020-02-16T20:20:13+00:00
A book-like container for all your things in need of a place to hide! Check out the larger version here: https://www.myminifactory.com/object/3d-print-book-hide-large-112461
Create your own cover with your favourite CAD, simply by drawing a 54x70x1mm square, with 45 chamfered edge on the bottom!
The book is assembled as follows:
Separate the two sides of the Cover after printing.
Remove the built-in supports under the hinge and the lock pin.
Clean all finish all parts.
Do a test fit, make sure the Upper and Lower Pins go in all the way without resistance and spin freely, and the pages fit nicely.
Insert the pins and glue the Pages to the back cover (this goes over the pins ends, locking them in place).
Hide your things.
Toss a like, post a make and maybe follow me over at the IG's
https://www.instagram.com/superbeasti/
Nothing special to note
| Date de publication | 16/02/2020 |
| Sans support | YES |