Creality Ender 3 X Axis Linear Rail Mod
Creality Ender 3 X Axis Linear Rail Mod
Published 2019-08-30T10:20:12+00:00
Linear Rail.
X Linear Rail Mod.
----------------------------------------
----------------------------------------
note
Have now eventually got around to uploading a version for the MGN12H rail as well, apologies to anyone that was waiting for the long delay.
The new MGN12H version and the Updated MGN9H version now use a seperate standoff for the hotend to make print orientation easier.
The MGN12H Mod adds an additional 3.5mm to the Y Offset on top of the Original 7mm Offset.
----------------------------------------
Just a very simple X Linear rail mod using an MGN9H rail, Y offset is increased slightly due to the rail carriage but it isn’t by much just 7mm.
You will need to file or grind a small bit of material away from the Extruder cover mounting lug where it catches the bottom M3x6mm mounting bolt.
I bought a longer rail 330mm because i don't use the endstops, most suppliers will cut to any length you need though.
You don’t need any additional hardware other than the rail itself and a few M3 T-Nuts and some Bolts:
Alignment Jigs and Drill Guides
----------------------------------------
Materials:
1 x 320mm long MGN9H Linear Rail - Aliexpress
or
1 x 320mm long MGN9H Linear Rail - Aliexpress
8 x M3 T-Nuts - Aliexpress
12 x M3x6mm Cap Head Bolts
2 x M3x25mm Cap Head Bolts
3 x M3 Locknut
1 x M3 Washer
And That’s it.
Printed in Sunlu Filament Black PETG purchased from Amazon.
Nozzle : 0.4
Layers : 0.2
Print Temp : 20°C
Bed Temp : 75°C
Print Speed : 50mm/s
Top Layers : 5
Bottom Layers : 4
Perimeters : 3
Infill : 60%
Printed on PEI.
Date de publication | 30/08/2019 |