Double Dabbing Dickbutt Zoetrope
Double Dabbing Dickbutt Zoetrope
3D
Published 2019-10-11T04:25:13+00:00
A Zoetrope of the famous reddit mascot "Dickbutt" doing a double-dab maneuver. See our viral post on Imgur for videos https://imgur.com/gallery/cmCYq51
The mounting point is designed for a standard snap-locking DVD motor. It is designed with bottom slots to allow light into the chamber, which is a feature of our Hex Strobe Docks and Wooden Strobe Docks. It was then printed in Natural clear PLA to allow light to diffuse through the plastic from within.
If designing a motorized strobe dock of your own, it can also be printed in a colored plastic and bathed under white or colored strobe lights from above. Strobe Docks can also be purchased on our website at Novatropes.com
The sculpture should be rotated at around 500 RPM, with a strobe frequency of ~40 Hz and a duty cycle between 0.5 and 2% (lower is better, but will decrease brightness). Note: RPM and frequency have not been recorded for this model, experimentation will be required. Brightness can be increased by over-volting your LEDs, which is only safe at very low duty cycles (over-volting will burn out LEDs if left on for more than a second so be careful).
Note: Mounting snap-hole dimensions are very precise. Print with a .4mm nozzle (only PLA has been tested but other plastics may be possible). Printing with a raft is also imperative, as even slight bed leveling imperfections will result in the statue "wobbling" during operation and creating unpleasant visual noise.
Nozzle must be 0.4mm for mounting snap-hole to properly mount to a standard snap-locking DVD motor.
MUST be printed with a raft to avoid spin-wobble based on slight bed-level inaccuracies.
| Date de publication | 11/10/2019 |
| Durée d’impression | 7 - minutes |
| Quantité de filament | 203 g |
| Dimensions | 125mm x 125mm x 44.75mm |
| Sans support | YES |
