Hook for Face Masks
1,248
views
38
downloads
1
collection
Community Prints
Add your picture
Soyez le premier à partager une photo de l'impression de cet objet
0 comments
Loading comments... 
Hook for Face Masks
3D
Published 2020-10-18T14:20:15+00:00
22
0
Add to Collection
Description
A hook designed to make your mask attach or the back of your head and not in the ears, so that it doesn't cause pain. (Disclaimer: This might not work with all masks!)
If you need this to be shorter, don't scale it down. Rather check out the Double Hook instead.
Hardware Required:
- An elastic band (preferably cloth, but rubber works as well)
Building Instructions:
- Print 2 hooks (no supports or adhesion needed)
- Tie the band on one hook and hook it on one band you your mask
- Put the mask no your face and pull the bands as close to each other as they will go, so that your mask is firmly on your face, but it is not too tight.
- Measure that distance - If the distance is sorter than the hooks can provide, try out the Double Hook
- Cut the band that is attached to the hook at roughly that same length
- Tie the other end of that band to the other hook
- Place the mask on your face and attach the hooks at the back of your head. If the mask is too tight or too lose try again with a different length of the band.
- Wear a mask and be proud!
Licence
Technical Information
| Date de publication | 18/10/2020 |
| Sans support | YES |
More Information
Object Parts
