Size: you can print the figure in any size you want. My figure was printed in 1/6 scale (30cm / 12") so I had to enlarge each part in cura by 168%.

IMPORTANT: The base hole may be a bit small to fit the leg pole once it's printed. That's due to a number of factors such as printing the base with a different layer height  compared to the other pieces, PLA heat/cooling variations or inconsistent extrusion etc...To avoid that, make the base is slightly larger  (you can increase the size percentage in cura for instance) so you wont have any issues fitting the leg into the base hole.  Alternatively you can use a heat gun for a few seconds on the hole so it leg can fit the cavity. If the base hole is too big for the legs when you try to join/connect them together you can roll a seller tape a few times around the leg pole so it will fit properly into the base cavity.

Leg: the right leg is slighty over ground. That was intentional as I planned to do a diorama where Kitty’s foot would be on top of stone or other prop. You can use your imagination and add anything you want to the base in order to fill the gap (if that bothers you).

Post-Printing:You will need superglue to join all the pieces together. Make sure you use a strong one such as Loctite all purposes superglue (gel had the best results in my trials) or any similar brand. Avoid epoxy as the parts will need to be clamped for a while in order to work (not an option here due to the nature of the model).
Sanding and priming (ideally with a filler) are a must here if you intend to airbrush it or paint over it.

Painting (paints  I  used in this figures and alternative/suggestions)

Airbrush/Brush (alternative):

Body (yellow stripes, boots and gloves): Vallejo Air – gold Yellow /  Vallejo Model Color -Flat Yellow

Body (base colour)- Vallejo model Air Black / Citadel Abaddon Black

Hair:  Citadel leather Brown followed by Agrax EarthShade

Lips: Vallejo Model Colour – Rose Brown

EyeShadow: Vallejo Metallic medium

EyeBrown/Eyelash: Vallejo Model Air Black  with quite a bit of medium (so the colour gets a bit transparent) .

bodysuit: Vallejo  Black (alternative/suggestion citadel abaddon black 

Eye: Citadel white scar with tiny bit of grey (suggestion citadel white scar), vallejo brown for the iris, vallejo black for the pupil.

Gloss finish (lips, Eyes and Lockheed’s eye): Vallejo Acrylic "Gloss Varnish"

Lockheed:

Body: Vallejo Air Warlord Purple / Citadel Phoenician Purple

Fang and Claws: any white or light grey Paint.

Eye: any vibrant yellow/mustard paint.