Magentic Geared Fidget Spinner
Magentic Geared Fidget Spinner
3D
Published 2017-11-30T16:08:51+00:00
Geared fidget spinner based off of several other designs I've seen, I'm not sure where it originated from. The bearings are linked so spinning the case around the central bearing spins the outer bearings and vice versa. This one uses magnetic gears instead of traditional gears.
Parts:
Uses 48 - 4x2 magnets* on the gears, more if you also use them to hold the parts together (or you can use glue dots*. The magnets on the gears alternate between north and south facing out.
Needs 5 - skate bearings* (there are two in the center). It'll probably work better with ceramic ball / magnetic steel bearings*, but I used normal metal bearings (which are affected by the magnets and only spins for a few seconds).
Filament:
Atomic Filament Starry Night PLA and Filamentum Vertigo Gray* and Rapunzel Silver* PLA.
*affiliate links
ok
| Date de publication | 30/11/2017 |
| Durée d’impression | 55 - 110 minutes |
| Quantité de filament | 7 |
| Dimensions | 55 55 11 |
| Technologie | FDM |
| Complexité | Easy |
