OCULUS SENSOR ADJUSTABLE WALL AND CEILING MOUNT
OCULUS SENSOR ADJUSTABLE WALL AND CEILING MOUNT
Published 2020-03-11T10:52:55+00:00
A wall or ceiling mount for the sensors of the Oculus Rift. Just two parts and a little hardware
Parts - Wall Mount Bracket and Swing Arm
Hardware needed unless you can substitute.
2 - Brass Thumb Screw, Knurled Head, 0.75" Length, Fully Threaded, 1/4"-20 UNC Threads
2 - Hex Head Nut 1/4"-20 UNC Threads
2 - Stainless Steel External Tooth Star Lock Washers
2 - Screws for direct screwing into stud or anchor screws
These are the primary settings. Your slicer may have other variables of your choosing.
The wall bracket is 35mm x 50mm x 90mm
The swing arm is 25mm x 93mm
Extrusion Width - .20mm
Infill - 15% with 30% overlap
Extruder temp - 215C first layer, 210C 2nd and on
Heatbed temp - 60C
Cooling temp - 0 first layer 100% 2nd and on
Speed - 40mm
Date de publication | 11/03/2020 |
Durée d’impression | 190 - minutes |
Quantité de filament | 32.55 |
Dimensions | Mount -35mm x 50mm x 90mm and Swing arm -25mm x 93mm |
Sans support | YES |