Pax 2/3 Charger Station
Pax 2/3 Charger Station
3D
Published 2018-02-23T13:14:48+00:00
After two revisions here a nice and well-fitting station that accomodates the pax charger holding the pax in position during charging. Very usefull for charging in the car or bag, or simply to have a nice stand for the pax at home, for this the cable has space to allow for both horizontal and vertical position.
I printed it in white ninjaflex, other flexible filaments would work, standing upright with the cable hole at the bottom, no need for supports or big infill. I added a picture to show the tight fit and how it deforms when the pax is inserted, rigid filaments will not work...
Hope it will help other pax vaporists!
Ninjaflex, upright, no supports, 0.15 mm layers, 20 mm/s max speed reduced on external perimeters, need for good bridge settings for the top (on my print 20 mm/s was a bit to fast).
| Date de publication | 23/02/2018 |
| Durée d’impression | 6 - minutes |
| Technologie | FDM |
| Complexité | Easy |
| Sans support | YES |
