Pocket Door Hanger / Hinge
3,705
views
85
downloads
Community Prints
Add your picture
Soyez le premier à partager une photo de l'impression de cet objet
0 comments
Loading comments...
Pocket Door Hanger / Hinge
3D
Published 2015-06-16T11:48:51+00:00
12
0
Add to Collection
Description
This is a replacement part for a pocket door. It screws into the top of the door and provides the bearing surface for the door to slide on it's rails. It is designed to be printed in PLA, investment cast, and then threaded. The thread pitch for the original part that was duplicated was 5/16-32, so was too fine to print or cast successfully.
In the picture, the original die cast piece is on the left and three replacement parts that were printed in PLA and then cast in brass are shown on the right.
Détail de l'impression
Print at 0.2 mm layer height, with 10% infill. This uses 1 g of filament and takes 5 minutes.
Technical Information
Date de publication | 16/06/2015 |
Durée d’impression | 5 - 10 minutes |
Quantité de filament | 1 g |
Dimensions | 13 x 40 x 13 |
Complexité | Very Easy |
More Information
Object Parts