Poly Lotus Novatrope
Poly Lotus Novatrope
3D
Published 2019-10-10T23:10:12+00:00
A 3D Zoetrope designed using the fibonacci sequence and golden spiral.
The mounting point is designed for a standard snap-locking DVD motor. It is designed with bottom slots to allow light into the chamber, which is a feature of our Hex Strobe Docks and Wooden Strobe Docks. It was then printed in Natural clear PLA to allow light to diffuse through the plastic from within.
If designing a motorized strobe dock of your own, it can also be printed in a colored plastic and bathed under white or colored strobe lights from above. Strobe Docks and additional Novatropes can also be purchased on our website at Novatropes.com
The sculpture should be rotated at around 900 RPM, with a strobe frequency of ~40 Hz and a duty cycle between 0.5 and 2% (lower is better, but will decrease brightness). Brightness can be increased by over-volting your LEDs, which is only safe at very low duty cycles (over-volting will burn out LEDs if left on for more than a second so be careful).
Note: Mounting snap-hole dimensions are very precise. Print with a .4mm nozzle (only PLA has been tested but other plastics may be possible). Printing with a raft is also imperative, as even slight bed leveling imperfections will result in the Novatrope "wobbling" during operation and creating unpleasant visual noise.
Nozzle must be 0.4mm for mounting snap-hole to properly mount to a standard snap-locking DVD motor.
MUST be printed with a raft to avoid spin-wobble based on slight bed-level inaccuracies.
| Date de publication | 10/10/2019 |
| Durée d’impression | 6 - 7 minutes |
| Quantité de filament | 105 grams |
| Dimensions | 118.8mm x 118.5mm x 32.8mm |
| Sans support | YES |
