This kit is developed to add the Motor Drive Device for my following model as option.
In this model, there are many places that generate unavoidable rotational drag, and if it is too large, driving by the motor may be difficult.
But if engine is rotated by the knob lightly with your finger, it can be rotated by the motor.
The biggest drag is generated by friction between the No.1 and No.5 cylinders and the piston.
It is important to smooth the layer step on the inner diameter of the cylinder, and the sharp edge of the outer diameter of the piston and the layer step.
In my case, I was able to somehow drive the motor without using grease.
However, I cannot guarantee the motor drive for everyone, so please only challenge those who are confident.
Fig.01 - Modified parts
Fig.02 - Additional Parts - Frame and Stand
Fig.03 - Additional Parts - Motor Parts
Fig.04 - Final Assembly pictures
B. Purchase Parts Information;
-Motor - Geared - See Fig.03
Micro screws M1.4x6L - Direct screw-in to 1 mm dia hole (No nut)
But if you have the M1.4 Tap, it will be very useful.
Screws & Nut M2 x ** - See Fig.2 & 3
D. STL file
Total STL files are 8 items including the stand and tools.
“ws” of last 2 digits of file name means “With Support” special designed.
E. Total Net Print Time: Approx. 13 HR
- (Estimated as case of PLA, 0.4mm Nozzle, 0.2mm Layer Height, 40% infill and No raft and support)
Note: When at actual print, each parameter may be adjusted by your experience.
F. Printing settings
Raft, Support, Layer Height, Infill: Depending on your experience.
My models were printed by "idbox" using with 0.4 nozzle, 1.75 PLA.
I wish you success.