Tetris 99 Maximus Cup - Tetris Trophy
Tetris 99 Maximus Cup - Tetris Trophy
3D
Published 2019-04-29T16:29:52+00:00
With the recent release of Tetris 99 for the Nintendo Switch and discovering some streams and events held by https://thectwc.com/ I was inspired and overcome by nostalgia gaming again.
Even though 999 Nintendo Points to the top competitors was cool, I thought this may be a cool way for those to have a physical way to remember the little event.
I'll upload versions without the Maximus Cup on it as well so if people would like to make them for something else.
Boom Tetris!!!
Printer: CR-10 Mini
Supports: Yes
Resolution: 0.2-0.3
Infill: 20+
Filament: StrongHero3d PLA Gold
Notes:
I adjusted my printer to have a layer above and below the supports. This enabled me to have two small cubes post-print that I can use or just throw at something.... :P just a suggestion to sometimes utilize support material. Though depending on your print orientation this may not be an option.
| Date de publication | 29/04/2019 |
