Tres (Caffitaly) Rotating Capsule Holder
Tres (Caffitaly) Rotating Capsule Holder
3D
Published 2020-10-02T11:14:56+00:00
To build this, you'll need to print:
Base.stl one time
Cover.stl one time
3xSpider.stl three times
6xInsideHolder.stl six times
6xOutside Holder.stl six times
In terms of hardware, you'll need:
3mm drill bit
M5 Tap
one M5x25mm screw
thirty six M3x15mm screw
Mineral oil or silicone lube
Print all the parts according to the number in the filenames, add more walls and infill to the base so it's heavier and more stable.
Tap the hole in the Base with a M5 tap (you can also experiment with using self-tapping screws instead, but it might chip the plastic along the layers), clean the holes in the inside and outside holders with the 3mm drill bit, force the M3 screws into the outside holders, then the inside holders and lastly into the spider, start by the middle spider.
| Date de publication | 02/10/2020 |
| Quantité de filament | 427g |