"Trollface" (Coolface) meme character (Little-Meme)
"Trollface" (Coolface) meme character (Little-Meme)
3D
Published 2015-03-05T01:10:50+00:00
This is a little character inspired by Rage Comics and internet memes, I call them "Little-Memes".
(See: knowyourmeme.com/memes/rage-comics)
I started selling these little guys on Etsy, but it was too much for one man, so I'm uploading them to My Mini Factory :D
Please experiment with settings for your printer, but these are what worked for me: (Tested with PLA) Layer Height of "0.11mm" at default scale, to preserve detail. If your printer has 1 extruder fan, then rotate the character so the fan is blowing on the "back of its head". Print at a "low" temperature (around 205C). "Disable" filament Retraction over gaps. Minimal Layer Time "15 seconds" (at a fill density of 30%, and print speed of 50mm/s). Snap off the arm-supports after the print is complete. Use a knife to remove the teeth supports.
| Date de publication | 05/03/2015 |
| Durée d’impression | 250 - 300 minutes |
| Quantité de filament | 15 grams |
| Dimensions | 60mm high |
| Complexité | Medium |
| Sans support | YES |
