Jyn Erso's blaster from Star Wars: Rogue One
Jyn Erso's blaster from Star Wars: Rogue One
Published 2020-03-02T16:45:12+00:00
This is a replica of Jyn Erso's blaster from Star Wars: Rogue One and therefore, the intillectual property of Disney. I do not have the right to sell this property and anyone wishing to do so must obtain licensing/permision from Disney.
I modeled this off of movie/canon photos and blueprints of the Luger P08 (gun the actual prop is based on). Some details are not clear from the movie/canon photos so I used the Luger blueprints to fill in the blanks.
I printed it with a lot of the smaller peices separate such as the grips, trigger, lower grip screw head, bead eylet, magazine base, and slide release. This was so I could make it look more authentic (especially the paint job). However, I have included a .zip file where all these peices are part of the body. Therefore, you would only have to print the two body halves. It is labeled Jyn_blaster. The file labeled Jyn_blaster_more_pieces has all the smaller pieces mentioned at the begining of this paragraph as separate .stl files.
For added detail, I insalled four M2x4 screws on each side in the designated 2mm holes. The screws threaded snuggly into the holes without the need of a drill and/or tap. I then weathered the blaster with black oil paint and a rag. I applied the oil paint to most of the blaster and then wiped off the excess with a rag. This allows the paint to build up in the grooves and cracks, just like dirt would over a long period of time.
I printed all the pieces in PLA on the Prusa i3 Mk3S with 10% infill. I also used supports on the build platform only for some small overhangs.
Date published | 02/03/2020 |
Time to do | 6 - minutes |