Nintendo Switch Portable Charging Stand
Nintendo Switch Portable Charging Stand
Published 2017-03-13T16:53:27+00:00
This portable Zelda-themed charging stand is the perfect solution to a common issue with the Nintendo Switch. This stand features:
-Fold-flat design that fits into the same footprint as the Switch, meaning you can pack it into your travel case with your Switch!
-60 degree angle gives ideal viewing position
-Play your Switch while charging! Charging cable can be run through the front or out the back of the stand
-Wide base gives it a lot of stability
-Simple three-piece assembly. The hinge pins are made from 1.75mm filament. Just cut a piece and slide it through the hinge holes. Can also be disassembled by sliding the filament back out.
When inserting the filament into the hinge I suggest cutting the filament end at an angle. This will help the filament feed through the hinge holes. You may need to use a pair of pliers to insert the filament hinge pin. It should be firm but not impossible to insert. If it's too difficult you can expand the hinge hole with a drill bit.
Update: I have added a new center piece called Switch Stand Center Foldable. This piece has two hinges of differing height, which allows you to fold the arms inward. The center piece is also a bit wider than the original, so the arms can fold completely within the width of the center.
I recommend using a brim to help prevent the corners from curling up. 0.2mm layer thickness seems to work well.
Date published | 13/03/2017 |
Time to do | - 120 minutes |
Support Free | YES |