Rocking boat
This object has been checked for printability, but did not pass the test and was deemed not printable. This object is still shareable and people with this link will be able to see and download the object, so please make sure you watch out and progress with care!
×Rocking boat
This object was made in Tinkercad. https://www.tinkercad.com/things/ktV6ctjmqSr This Is a model of a steamboat sailing. When the crank is turned, the boat will rock forward and back, up and down, and from side to side. Moderate sanding/gluing may be required. I made the boat unattached to the base, so that it can be replaced if you decide to make your own boat. The boat will fall off if you crank too quickly.
Depending on the size of your printer, you may have to print it in parts. Some parts, like the main crank rod, could be replaced by a similarly sized wooden dowel. The rods in this design are all just a hair over 4.5mm. The only place supports are needed is for the crank in the mechanics file.
Status | Rejected |
Material Quantity | 315g |
Dimensions | 250mmX250mmX120mm |