Halo 4 Needler Prop Weapon
This object has been checked for printability, but did not pass the test and was deemed not printable. This object is still shareable and people with this link will be able to see and download the object, so please make sure you watch out and progress with care!
×Halo 4 Needler Prop Weapon
3D
I have designed the Halo 4 Needler weapon. This is close to, but not a perfect replica of the weapon seen in the game. This is designed with custom LEDs and switches in mind, pink and blue LEDs for the Needles and Lights. This model is about 23 inches long and about 18 inches tall fully assembled. It is designed with custom LEDs, battery box, and switches in mind. There is also a stand that comes with the design with classic Halo symbols.
The printing specs I am using are as follows. .4mm nozzle, .3mm layer height, support everywhere @35 degrees, 5 perimeters, 5 bottom and top solid layers, 60mm/s support and infill speed, 40mm/s outside perimeter speed, raft at .2mm air gap. Approximate material usage and time is 3Kg and 171 hours Each part is cut into segments that may be printed in the single color as it appears in game, purple, pink, grey, black..... Print one of everything except for as follows. Print 10 alignment pin 9.5x38, print 4 alignment pin 9.5x18, print 4 LED holder front tip, print 7 LED holder back, print 14 Needles.
| Status | Rejected |
| Time to do | 10260 - minutes |
| Material Quantity | 3000g |
| Complexity | Difficult |