Elegoo Mars Pro Internal Carbon Filter Housing
This object has been checked for printability, but did not pass the test and was deemed not printable. This object is still shareable and people with this link will be able to see and download the object, so please make sure you watch out and progress with care!
×Elegoo Mars Pro Internal Carbon Filter Housing
A replacement of the internal carbon filter housing that comes with the Elegoo Mars Pro.
The charcoal block is hot glued inside the original and was no longer working to get rid of the resin smell. After removing the filter with some water (it dissolves) I cracked the case trying to get the glue out. 3D printing to the rescue!
I'd recommend cutting a Carbon Pad into sections to fill the inside of it with.
There are a couple small differences between this and the stock version that won't cause any issues in use but should be noted. My version doesn't have the very slight inward angle as the official, the outside rounded edges aren't as rounded, and because the side thicknesses varied wildly on mine from 1.5 to 2MM I made the top casing slightly wider wise than stock and made the thickness 2MM for ease of printing. Internal dimensions are identical to the original
Printing with supports is a must with the legs of the housing on the bed of the printer.
Status | Rejected |