Quest 2 Headstrap V1.1
3,688
views
315
downloads
2
collections
7 comments
Loading comments...
Quest 2 Headstrap V1.1
3D
Published 2020-11-30T14:12:29+00:00
17
7
Add to Collection
Description
This Headstrap utilises a ratchet mechanism to lock the headstrap in various postions to tighten or release it from one's head. Additionally there is a mechanism to realign the straps incase there is misalignment. Please be aware that this design is based on the use of PETG filament.
To assemble the headstrap:
- From the original quest 2 headstrap, separate the side straps from the upper strap.
- Insert the two side straps into the main body.
- Insert the rear knob - this will take a lot of force, so i would advise pressing the walls from the opposite side to help prevent layer separation.
- Insert the ratchet into the ratchet housing
- Install the ratchet housing +ratchet onto the main body with the help of a flat head screwdriver, turn the knob clockwise to help the parts align.
- Insert the latch and secure onto the quest 2.
License
Printing Details
Print settings:
All parts
- Material: PETG
- 0.4 line width
- 3 walls
- 4 floors
- 5 roofs
Main body
- sitting vertically on the printbed (top strap latch pointing upwards)
- supports enabled, with roof
- block supports from generating within the hollow cavity (where the side straps go)
- a .25 layer height would speed things up, however 0.2 is recommended
- 15% infill
- Fan 30%
Side straps - (prints will vary, but the straps should come out at 1mm thick, if >1.2mm mechanism movement will be stiff)
- 0.2 layer height
- no supports
- 100% infill
- Fan 30% from 1.2mm
Ratchet housing
- 0.2 layer height
- supports enabled
- plain side down on the bed
- Fan 30%
Knob
- 0.2 layer height
- Fan 30%
Ratchet
- 0.2 layer height
- Fan 20%
Latch
- orientation- concave pointing down on bed
- 0.1 layer height
- supports with support roof enabled
Technical Information
Date published | 30/11/2020 |
More Information
Object Parts