Taco Holder
This object has been checked for printability, but did not pass the test and was deemed not printable. This object is still shareable and people with this link will be able to see and download the object, so please make sure you watch out and progress with care!
×Taco Holder
Published 2014-07-03T00:32:15+00:00
This is a taco holder designed to hold 3 tacos or burritos. I have printed this design and refined it several times. Photos of the print are included. On taco night at my house, I can barely keep up with my kids. With 5 people at the table, someone needs a new taco about every 2-3 minutes. The purpose of the taco holder is to make it easier and faster to build a taco. Soft or hard, you can sling all the ingredients by request and make everyone happy. The taco holder keeps it upright so nothing falls out while you are building it. My kids even like to be served with them just for fun. Each holder fits 3 tacos at once. I have printed 3 of these taco holders with PETT food safe plastic so I can make 9 tacos at once. (Photos to come soon) The design is meant to be rugged and allow for actual use without breaking. Hand wash with light soap and water recommended. This model does not require supports to print.
Printed at 0.25 mm layer height, with 25 % infill. This took 163 minutes and used 57.8 g of filament.
Date published | 03/07/2014 |
Time to do | 163 - 163 minutes |
Material Quantity | 57,8 |
Dimensions | 5 cm x 12,4 cm x 5,8 cm |
Complexity | Very Easy |