A wall mount/holder for three Dyson cordless vacuum cleaner accessories, compatible with Dyson V7, V8, V10, and V11 (was only tested on V8, but the accessories for V7-V11 should be the same).

I made this because there was no satisfactory storage solution for most of the accessories with the mount included with the vacuum.

The two holders on the right were designed to fit the mini motorized tool and the soft brush tool as seen in the cover picture, hence the angle and spacing. The left holder can fit the crevice tool, the combination tool, or any other narrow and straight tool.

The mount has three 3.5mm (~9/64 inch) diameter holes for wall mounting screws, although using only two screws is probably sufficient. Do not over-tighten the mounting screws as doing so will crush the 3d printed part.

Print with supports and decent shells and infill for strength.

Fusion 360 (.f3d) and STEP files have also been included for anyone to edit.