The display base is separated into 3 parts for easy printing and colour swap. The parts are:

1) Base
-BaseV3 - Patch.STL

2) Base back wall:
-BoxBackAssem.STL

3) Name Plate:
- NamePlate2.STL

Print Settings
Nozzle size = 0.3 mm (0.4 should be printable but smaller better)
Layer height = 0.2 mm

Filament change layer for colours on "BaseV3 - Patch":
1) Start (Right stripe, mine is in red)
2) Layer 11 (Middle stripe colour, mine is in white)
3) Layer 16 (Left stripe colour, mine is in green)
4) Layer 21 (Overall base colour, mine is in black)

Filament change layer for colours on "BoxBackAssem":
1) Start (Stripes background colour, mine is in black)
2) Layer 5 (Overall background and lowest stripe colour, mine is in red)
3) Layer 9 (Top stripe on base and Ferrari logo, mine is in green)
4) Layer 14 (90 Years logo, center stripe of base and Ferrari logo colour, mine is in white)
5) Layer 19 (Ferrari logo background, mine is in yellow)
6) Layer 24 (Ferrari logo outline, horse and details, mine is in black)

Filament change layer for colours on "NamePlate2":
1) Start (Plate colour, mine is in black)
2) Layer 7 (SF90 lettering colour, mine is in white)
3) Layer 12 (Stradale lettering colours, mine is in red)

Assembly
The car is tied by wires through the hole in the base

Back plate should slide in nicely into the display base, name plate will need to be glue or double sided tape on to the base.

Others
Feel free to send me any feedback on how to improve the design. Suggestion on display base designs are welcomed too.

I can be contacted through Instagram or Twitter too:

Twitter: https://twitter.com/Giga_Penguin
Instagram: https://www.instagram.com/GigaPenguin3DPrinting/

If there is any minor edits you want, send me a message or comment!