SCX24 Cross-axle and Incline/Decline Test
SCX24 Cross-axle and Incline/Decline Test
3D
Published 2022-07-04T08:26:57+00:00
This is a test track and adjustable inserts for both cross-axle and incline/decline testing. It will print on any Ender 3 size (220x220) printer. You will want six of the track pieces and at least two of the spacers. The spacers allow for adjustable width from 70mm up to (at least) 130mm and all pieces are 30mm wide. M1.4x3mm screws are needed for assembly.
The incline/decline ramp is curved and set up for ~134mm trucks. That is all of the stock SCX24 wheelbases except the Gladiator. Longer and shorter wheelbases WILL NOT measure accurately. Traction tape is recommended.
PLA/PLA+ is fine.
0.2 layer height
No brim needed if your bed adhesion is good
Supports needed for cross-axle bumps and incline/decline ramp
| Date published | 04/07/2022 |