Micro Quad-racer 2S 90mm polycarbonate
This object has been checked for printability, but did not pass the test and was deemed not printable. This object is still shareable and people with this link will be able to see and download the object, so please make sure you watch out and progress with care!
×Micro Quad-racer 2S 90mm polycarbonate
The light and airy architecture of the 90mm frame has been possible due to the soliditer and stiffness of the polycarbonate.
Be very careful in flight with other filaments
Frame in polycarbonate Ultimaker 90 mm center distance with a flight controller sp racing evo . It is fully configurable and cleanflight on all flights modes
F.C. :http://bit.do/SP-racing-evo-hexa
Coreless: http://bit.do/coreless-chaoli-8-5x20-2S
Recpteur: http://bit.do/DSM2-5CH-2-4Ghz-RC-Micro-Receiver-With-6-CH-PPM
Camera 25mw: http://bit.do/Camera-TX01-Super-Mini-aio_8G-40CH-25MW-VTX-600TVL
Camera 200mW: http://bit.do/camera-Super-Mini-AIO-5-8G-40CH-200mW-VTX-600TVL
lipo: 300mha 2S : +/- 3-4min
screws: 4x M1.6 x 5mm
The fixing part lipo is glued to the frame.
At the time of bonding, move lipo fixing on one side as the antenna and its protection are in the passage of the propellers.
The Camera 25mW and 200mW mention in the links above if its compatible with camera protection.
A flat top cover larger and larger and compatible with the greatest receivers is being prepared.
Status | Rejected |
Time to do | - 4 minutes |
Material Quantity | 14gr |
Dimensions | 80x80 |