Siemens fridge / freezer handle bar mount
Siemens fridge / freezer handle bar mount
Published 2018-01-29T10:21:36+00:00
This is the plastic part from the handle bar used on many models of freezers and refrigerators from Siemens. As a sparepart this handle bar is sold complete which makes it quite expensive. As it's only the plastic part that normally breaks I think it's o good idea only to replace that part, both to save on money and resources.
Iv'e used gray PLA and printed it slow (30mm) with 0.1mm height.
It's important to make the walls thick enough to meet in the part where the mounting hole is. I used 2.4mm walls in Cura. Otherwise 10-15% infill works fine. I like the Octet infill for added stability and concentric top and bottom for the looks. On the picture it's the gray mount on the fridge that is printed and the broken original that I hold in my hand. Min time is for one handle at 60mm/s and the max time is at 30mm/s for a pair.
Date published | 29/01/2018 |
Time to do | 150 - 540 minutes |
Material Quantity | 20g |
Dimensions | 83.2x23.6x43mm |
Technology | FDM |
Complexity | Easy |
Support Free | YES |