Monopoly Community Chest Card Holder
Monopoly Community Chest Card Holder
Published 2018-05-14T10:15:44+00:00
Monopoly Community Chest Card Holder
This is a holder for the Community Chest Cards in Monopoly. It was designed for use with the cards in the standard version of Monopoly, and should fit other editions so long as the card sizes are the same. It has thumb slots on each end and a groove running down the center, length wise, to accomodate the use of a rubberband to keep the cards in the holder while not in use.
Disclaimer
Although I usually print at a layer height of .1mm, the card holder in the picture was printed at .2mm because most people seem to print at that layer height. I also used the cheap fillament that came with my printer to print this, as I didn't want to waste my hatchbox fillament. So the quality around the letters is less than I'd like. It is printed in one piece, with tiny supports recommended for the rubberband groove. With finer print settings and quality fillament, this holder will look much cleaner than it already does.
** The walls on the ends are fairly thin at only two .4 mm layers wide, but unless you are beating them up they will not break **
General Print Settings
Layer Height .2mm
Top/Bottom/Perimeter 3 layers
Infill 20%
Time 1h 54 m
Fillament Length 7628 mm
Platic Weight 22.93 g
Date published | 14/05/2018 |