Edit Thing Ring Flash 300 LED for Nikon
This object has been checked for printability, but did not pass the test and was deemed not printable. This object is still shareable and people with this link will be able to see and download the object, so please make sure you watch out and progress with care!
×Edit Thing Ring Flash 300 LED for Nikon
3D
Published 2015-04-25T07:06:57+00:00
Ring-flash case for 300 LED.
Designed for Nikon 72mm hood holder.
(works fine with the AF-S NIKKOR 50mm f/1.4G)
This device is designed for Nikon lenses 72mm hood holder.
Print:
For filament prints, make sure you do not print skirt as it may obstruct the led pins holes and affect radius of led lense holes.
Printing the LED grid part with white material may increase luminisity.
LEDs:
You need 300 LEDs for this flash verssion. White LEDs can be purchased online, make sure you choose white light LEDs 5mm lense diameter. See led detail in pictures gallery.
Connect:
I chose to connect the LEDs in parallel to prevent from the all device shunting-down if one led fail. But serial connect shall work as well. Electric paint can save you lot of time.
Powering:
I'm using a variable power supply and a jack connector.
I set the power supply to 3V, 600mA.
| Date published | 25/04/2015 |