PolyPanel Wheel and Pully
This object has been checked for printability, but did not pass the test and was deemed not printable. This object is still shareable and people with this link will be able to see and download the object, so please make sure you watch out and progress with care!
×PolyPanel Wheel and Pully
Made this on Tinkercad. The PolyPanel itself has one end of a bearing for each panel. The Axel has the other part of the bearing, on both sides of it, to snap onto each of the polypanels. The wheel is placed on the axel and can be glued into place if need be as the whole axel is what rotates. Also, the pully is made up of 3 wheels. 2 are the large wheels and the wheel in the center is slighly smaller to make the gap. This is the way i decided to make the pully so there is no need for supports. Print each piece seperately and you can put it all together onto the axel.
Status | Rejected |
Support Free | YES |