Filament Guide
This object has been checked for printability, but did not pass the test and was deemed not printable. This object is still shareable and people with this link will be able to see and download the object, so please make sure you watch out and progress with care!
×Filament Guide
Published 2019-05-20T15:45:15+00:00
Snap In Guide, Many to choose from!
The Base Will fit tight but should not need any trimming, tested at a few resolutions.
Once its in the aluminum Snap In Guide, Many to choose from!
The Base Will fit tight but should not need any trimming, tested at a few resolutions.
Once its in the aluminum just click your guide in and call it a day.
If your printer hates to bridge, Print end clip with support lines at 1.8mm apart (5 lines total under roof) only touching build plate.
End Clip has been repaired, rear prongs are Back to thickness of original
Don't forget to cut any strands filling the top pillar or it will provide a lot of resistance.
Print Settings
Printer:
Ender 3
Rafts:
Doesn't Matter
Supports:
No
Resolution:
.1 to .18
Infill:
10% +
ج . م . ع - سوهاج 19-05-2019
احمد صبره يونس
Date published | 20/05/2019 |
Support Free | YES |