MiniBee
This object has been checked for printability, but did not pass the test and was deemed not printable. This object is still shareable and people with this link will be able to see and download the object, so please make sure you watch out and progress with care!
×MiniBee
It's a little frisbee that goes in a pocket. small project easy to print. a toy that needs good technique to succeed in launching it properly. throw it on the side, as if you throw a rock to make it bounce on the water. play on grass surfaces to avoid breaking the mini frisbee. I was inspired by a little frisbee already existing.
throw with the curved part down
only need support for the bottom.
I use lot of infill % to get a better weigh (like 75%)
but you can try diffrent setting.
pla and - petg work well.
Status | Rejected |
Time to do | - 240 minutes |
Material Quantity | 26g |
Dimensions | 62x62x15 |